Capability
R&D & Testing
Functional, environmental and durability testing supported by structured data analysis and design feedback loops.
A design is only finished when it has been proven. Our testing programme puts products through the conditions they will actually meet, then feeds the results back into the design so each revision is measurably better than the last.
At a glance
- Functional and performance verification
- Thermal and load stress testing
- Durability and life testing
- Structured failure analysis
01
Testing programme
- STEP 01
Product design validation
Software-based design and planning of new products, checked against the original requirement set at each revision.
- STEP 02
Prototyping
Early test models are built to observe how the design behaves outside simulation.
- STEP 03
Functional testing
Trials confirm that the product performs to specification across its intended operating range.
- STEP 04
Stress and durability testing
Units are exposed to extreme heat, cold and heavy loads to establish real margins rather than assumed ones.
- STEP 05
Data analysis
Test results are reviewed systematically to isolate the cause of any failure and drive the next design iteration.
Also available
Other capabilities.
SMT & PCB Assembly
Automated surface-mount assembly from paste print to reflow.
Design & Engineering
Concept to validated design, with simulation before metal is cut.
Quality & Inspection
Checks at incoming, in-process and final stages.
Custom Manufacturing
Machining, fabrication, moulding and in-house sheet metal.
Start a project
Need r&d & testing?
Send your drawings or a description of the assembly and we will confirm feasibility, approach and timeline.